Hello! I had my Blacet modules for a while in a Euro rack. With a
little pursuasion it worked but looked like the compromise it was.
There's a gap I coulnd't close with any panel format available.
Eventually I ended up with a Paia Frac Rack. I never tried to mount
D.s and B.s in the same rack but from my experience I think you must
be very much into DIY for a quarter-professional finish. Regards,
Ingo

--- In Doepfer_a100@yahoogroups.com , sfrules <sfrules@t...> wrote:
>
>
> Hello, gang!
>
> Has anyone had any experience mounting Blacet modules in the same
case with
> Doepfer modules (I know the power is not compatible.)
>
> In theory, both are 5.25 inches high. In theory, that is, because
the
> Doepfer fact sheet says they are about 4.9 mm shorter:
>
> "Module front panels are all 3U high (1U = 1.75 inch = 1.75" =
44.45mm,
> 3U = 133.4 mm). The final height of the front panels is a bit less
than
> 133.4 mm as the rim of the mounting rails has to taken into
> considerattion. Consequently the final height is 128.5 mm for all
A-100
> front panels."
> http://www.doepfer.de/home_e.htm
>
> Sorry for the cross-post but IMHO both are excellent products
worthy of
> sharing space in a portable cabinet.
>
> sfrules