I think I read your post a bit too quickly and misinterpreted your
problem... haven't had this problem myself.
Sorry.
Goodluck anyway.
/gustaf

--- In Doepfer_a100@yahoogroups.com , "gargar1974" <gustaf@p...> wrote:
>
>
> The trig outs output what you have in the clock in.
> What are you using in the input
> So if you drive it with a square lfo, it will output a rising edge
> and then a falling edge. Maybe what you are trigggering reacts to
> both I use it with the square wave from A-145 and send the trigger
> out to the A-140 and I dont have this problem.
>
> I think you'll like this module. I love it.
>
> /gustaf
>
>
> --- In Doepfer_a100@yahoogroups.com , "Paul Wagorn" <pwagorn@p...>
> wrote:
> > Ok, so I've only had this module for a short while, but I'm
having
> a strange
> > issue that is more likely me not understanding something than a
> problem with
> > the module:
> >
> > On the cv out for each row, at each step it actually pulses twice
> for each
> > "note" in the sequence. I don't have a scope to verify exactly
> what it's
> > doing, but if I pluf the pre or post out into an oscillator, it
> plays each
> > step twice (and I'm not using a vca!), I assume it's outputting
> some sort of
> > square wave for some reason. Even when I advance the step
> manually, for
> > each step it goes "beep - beep" (again without any vca)
> >
> > Am I missing something basic here I think I understand the
theory
> of the
> > 155, and I've had lots of other analogue sequencers, and I've
never
> seen
> > this.
> >
> > Paul