The trig outs output what you have in the clock in.
What are you using in the input
So if you drive it with a square lfo, it will output a rising edge
and then a falling edge. Maybe what you are trigggering reacts to
both I use it with the square wave from A-145 and send the trigger
out to the A-140 and I dont have this problem.

I think you'll like this module. I love it.

/gustaf


--- In Doepfer_a100@yahoogroups.com , "Paul Wagorn" <pwagorn@p...>
wrote:

> Ok, so I've only had this module for a short while, but I'm having

a strange

> issue that is more likely me not understanding something than a

problem with

> the module:
>
> On the cv out for each row, at each step it actually pulses twice

for each

> "note" in the sequence. I don't have a scope to verify exactly

what it's

> doing, but if I pluf the pre or post out into an oscillator, it

plays each

> step twice (and I'm not using a vca!), I assume it's outputting

some sort of

> square wave for some reason. Even when I advance the step

manually, for

> each step it goes "beep - beep" (again without any vca)
>
> Am I missing something basic here I think I understand the theory

of the

> 155, and I've had lots of other analogue sequencers, and I've never

seen

> this.
>
> Paul