Joe,

Could you expand on "I like to keep my A160 available for switching between the
A155's rows"

Regards

David



buechlerjoe
<buechlerjoe@toa To: Doepfer_a100@yahoogroups.com
dmail.com> cc:
Subject: 1 Re: Midi sync problem
22/12/2001 02:20 Header: Internal Use Only
Please respond
to Doepfer_a100





Hi bakis

I assume you step down the A190's clock output with an A160 clock
divider I like to keep my A160 available for switching between the
A155's rows. Is there another way

Joe

--- In Doepfer_a100@y..., bakis Sirros <synth_freak_2000@y...> wrote:
> hi joe,
> about your sync problem...i use the clock output of
> the a190 to sync my a155.and the "problem" that i have
> is that the a155 allways starts from the second
> step.(of course i have the reset out of the a190
> connected to the input of the a155...).i sync my a155
> to my old atari st.but it's not a real problem as it
> allways starts from the second step,everything else is
> o.k..it might be that i have my a190 connected to midi
> with my atari after a very long midichain.
> why don't you use the clock out of the a190
> bakis.
>
> --- buechlerjoe <buechlerjoe@t...> wrote:
> > I tried out the Shepard generator when I first got
> > the A191, but I'm
> > sorry not to have any creative thoughts regarding it
> > - I haven't
> > switched the A191 to Shepard mode since then. The
> > Midi/CV sockets and
> > the Midi-synced LFOs are far too useful to me. I
> > consider the A190/191
> > to be a single integrated Midi interface, and I
> > can't imagine trying
> > to get by with just the A190 alone.
> >
> > A thought occurred to me about my sync problem. My
> > previous master
> > clock source might have been confusing the A191 in
> > some mysterious
> > way, sometimes leaving it in phase, sometimes out of
> > phase. Perhaps it
> > was in the "out of phase" state when I switched over
> > to the Regelwerk.
> > I'm going to temporarily re-connect the original
> > clock source, and try
> > to get the A191 back to the "in phase" state. If
> > that doesn't work,
> > I'll directly email Doepfer about the problem.
> >
> > Joe
> >
> > --- In Doepfer_a100@y..., bakis Sirros
> > <synth_freak_2000@y...> wrote:
> > > hi and wellcome to the list!
> > > i wish i could help but,i don't have an a191...
> > > by the way,as you have this module,tell us ,have
> > you
> > > used the shepard generator any creative
> > thoughts
> > > synthfreak
> >
> >
>
>
>
> =====
> synthfreak(parallel worlds)
> athens-greece
> 1 group owner-moderator
>
> __________________________________________________
> Do You Yahoo!
> Send your FREE holiday greetings online!
> http://greetings.yahoo.com


Yahoo! Groups Sponsor








To unsubscribe from this group, send an email to:
doepfer_a100-unsubscribe@yahoogroups.com



Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.





-------------------------------------------------------------- --
Visit our Internet site at http://www.reuters.com

Any views expressed in this message are those of the individual
sender, except where the sender specifically states them to be
the views of Reuters Ltd.