> Hi again!
>
> So I'm removing the gate and CV bus access jumpers from my
> A-190-3, so I can plug its front outputs into the A-185's front
> inputs instead... As the A-190-3 doesn't appear to have any
> instructions yet, I'm using the A-190-2 instructions as a guide.
> I found the "gate bus" jumper (JP2) easily enough, and I *think*
> I've found the "CV bus" one too (JP3), but just wanted to make
> sure: is it just the bottom jumper There's three pairs of
> jumper pins right next to each other (JP11A and JP11B just above
> JP3), then a gap, then a fourth pair (JP10B) for what appears to
> be making the gate 12V. So was I right to take out the jumpers
> on JP2 and JP3, and leave the jumper in JP11A well alone
>
> Thanks!
> Zoë.

I have added page 13 of the preliminary A-190-3 user's manual to the info
page of the A-190-3. The document describes the functions of the jumpers.
The rest of the user's manual will come soon (but it's 98% identical to the
A-190-2).

You are right: removing JP2 and JP2 disconnects Gate (JP2) and CV (JP3) from
the A-100 bus.

Best wishes
Dieter Doepfer