Hi again!

So I'm removing the gate and CV bus access jumpers from my A-190-3, so I can plug its front outputs into the A-185's front inputs instead... As the A-190-3 doesn't appear to have any instructions yet, I'm using the A-190-2 instructions as a guide. I found the "gate bus" jumper (JP2) easily enough, and I *think* I've found the "CV bus" one too (JP3), but just wanted to make sure: is it just the bottom jumper There's three pairs of jumper pins right next to each other (JP11A and JP11B just above JP3), then a gap, then a fourth pair (JP10B) for what appears to be making the gate 12V. So was I right to take out the jumpers on JP2 and JP3, and leave the jumper in JP11A well alone

Thanks!
Zoë.