Doepfer now makes panels that have the 1/2 a screw space added to
allow AS stuff to sit next to Doepfer's without a gap. You want the
A-100B1.5 panels. They are 1.5HP wide. That takes up precious panel
space I know but it is a much easier procedure.
-James

On Apr 25, 2009, at 9:53 AM, infrequent wrote:

>
>
> On Sat, Apr 25, 2009 at 5:30 PM, achtung_999 <
> heinrich.himmelwasser@... > wrote:
>
> > Recently I converted one of the rows in my Doepfer rack to have M3
> > bolts inserted in the rails instead of the strip that normally holds
>
> On this exact point: is it possible to remove the rails from the low
> cost
> cases so that this strip can be replaced with nuts I'm also tired
> of my AS
> stuff being in a separate case.
>
> p.s. I presume from a power p.o.v. it's just a question of getting
> an AS bus
> board attached the the doepfer supply.
>
> [Non-text portions of this message have been removed]
>
>
>



[Non-text portions of this message have been removed]