On Sat, Apr 25, 2009 at 5:30 PM, achtung_999 <
heinrich.himmelwasser@... > wrote:

> Recently I converted one of the rows in my Doepfer rack to have M3
> bolts inserted in the rails instead of the strip that normally holds

On this exact point: is it possible to remove the rails from the low cost
cases so that this strip can be replaced with nuts I'm also tired of my AS
stuff being in a separate case.

p.s. I presume from a power p.o.v. it's just a question of getting an AS bus
board attached the the doepfer supply.


[Non-text portions of this message have been removed]