Guess Korhan had refered to how to trigger the A160! You can use
your LFO's square out for this. (Even some of the other outs will
*probably* work fine for the.) Regards, Ingo

--- In Doepfer_a100@yahoogroups.com , Florian Anwander
<Florian.Anwander@...> wrote:

>
> Hi Korhan,
>
> > Florian, thanks for the eloboration on the 160-161-151, but I'm

still not

> > clear how I can use these, since they are basically gate

sequencers and I

> > have nothing to trigger in my setup (yet). Or am I missing something
> Yes you are missing something ;-) The sentence of the day is: A gate is
> nothing than a voltage too!
>
> A gate is 5Volts. If you send this gate into the channel a mixer, and
> turn down the "volume" of this channel the half, then the mixer will
> output 2.5 Volts.
>
> Ok, now you take the first four outputs of a A-161. Step by step each
> output will have 5 Volts. Now every output is connected to the input of
> the mixer. At the mixer you adjust each channel with another "volume".
> Lets say, the first is half, the second is fully counterclockwise, the
> third is at quarter position and the fourth at 3/4 position.
> So the Mixer will output 2.5 Volts with the first step of the gate
> sequence; 0 Volts with the second step; 1.25 Volts with the third step
> and 3.75 Volts with the fourth step.
>
> As you see the Mixer "converts" the gatesequence into a voltage

sequence.

>
> Florian
>