Oh sorry!
My bad! I mean R419 (100K)
What other five resistors do (R420, R415, R409, R403, R402)
Paul write on his page about mod DMX cards what all of them for cutoff freq..
I think CEM wants 100k variable resistor, so can i just remove R419 and install pot

Thanks!

XOR

--- In oberheim@yahoogroups.com , "xorsister" <delon.alien@...> wrote:
>
> Hello there!
>
> I'm thinkin' about to add pots for cuttof & resonanse control of CEM3320 on my Oberheim DX..
> Anyone did this before
> As i can understand from schemes - resonance control is not wired at all (9) and cuttof (12) is fixed by resistor R412..
> Is this real to cut that resistor off and just wire a pot
> Or in case of resonance - wire pot straight to the 9 "leg" of CEM chip
> Since i'm musician, and not expert - tell me if i'm wrong :)
> I have seen on youtube mod for DX, where some guy made decay controls for every voice...
>
> here's the links:
>
> MOD ON YOUTUBE
> http://www.youtube.com/watch v=aCxfBKb0iOY
>
> DX SCHEMES (TOM CHANNEL, CEM3320 IN THE LOW RIGHT CORNER):
> http://www.electrongate.com/obfiles/dx_proc_5_of_7.jpg
>
> CEM3320 CIRCUIT DIAGRAMM:
> http://www.electricdruid.net/images/cem3320/larger/CEM3320LowpassFilter.gif
>
> Thanks in any advance!!
>
> XOR
>