Thanks !

--- In oberheim@yahoogroups.com , klosmon <klosmon@...> wrote:
>
> This comes up frequently (I've had several Matrix 6/6R units
brought in for
> repair with this "problem") -- it's another case of "RTFM" ("Read
The
> Friendly Manual").
>
> I quote from page 8: "When STEREO is set to ON, the LEFT/MONO jack
outputs
> all sounds from single patches and the sound from the LOWER patch
when in
> SPLIT mode; the RIGHT jack only outputs sound when in SPLIT mode,
and this
> sound comes from the UPPER patch."
>
> To learn how to access & program SPLIT mode, RTFM
> (read the funny manual)
> (read the fine manual)
> (read the funky manual)
> (READ THE FRIGGIN' THING)
> ;)
>
> ~GMM
>
> At 09:56 AM 12/17/2006, you wrote:
> >My Matrix 6R has a strange problem - no matter which preset you
> >select, with both Stereo option ON and OFF, only Left/Mono channel
> >works.
> >On headphones, on the other hand, you can hear both channels.
> >
> >I am trying to find out whether this is an electronic problem or if
> >there's something wrong in the setting.
> >
> >I tried the following to no avail so far:
> >
> >1. Full Reset ("Calibration")
> >
> >2. Replaced the 3 ICs at the final amplification stage, which are a
> >741, 4082 and 4053. When disconnecting
the "Left/Ground/Ground/Right"
> > wire going from the main voice board to the headphones/out board,
> >and checking the output jack on the voice board with an audio
probe,
> >only left channel plays, so I guess there is nothing to do with
> >neither the output jack board nor the headphones board.
> >
> >I can't see any component the might have an influence on the right
> >channel alone, beside those 3 ICs which I've replaced...
> >
> >Any suggestions
> >
> >Thanks
> >
> >
> >
> >
> >Yahoo! Groups Links
> >
> >
> >
>