I know about these. And I find it a less nice solution.
I just want to know if it is possible to remove the strips from the
rails of the standard suitcase, not the low cost case.
anyone

On Sat, Apr 25, 2009 at 7:34 PM, < james.husted@... > wrote:
>
>
> Doepfer now makes panels that have the 1/2 a screw space added to
> allow AS stuff to sit next to Doepfer's without a gap. You want the
> A-100B1.5 panels. They are 1.5HP wide. That takes up precious panel
> space I know but it is a much easier procedure.
> -James
>
> On Apr 25, 2009, at 9:53 AM, infrequent wrote:
>
>>
>>
>> On Sat, Apr 25, 2009 at 5:30 PM, achtung_999 <
>> heinrich.himmelwasser@... > wrote:
>>
>> > Recently I converted one of the rows in my Doepfer rack to have M3
>> > bolts inserted in the rails instead of the strip that normally holds
>>
>> On this exact point: is it possible to remove the rails from the low
>> cost
>> cases so that this strip can be replaced with nuts I'm also tired
>> of my AS
>> stuff being in a separate case.
>>
>> p.s. I presume from a power p.o.v. it's just a question of getting
>> an AS bus
>> board attached the the doepfer supply.
>>
>> [Non-text portions of this message have been removed]
>>
>>
>>
>
> [Non-text portions of this message have been removed]
>
>