I get it now.........could it be the the VER. Of the patches you are
loading are prior or forward of the hardware VER.....i had that
problem before.

As to the actual data patches...mine are long gone!
Try 'manual manor'.......they sometimes have the old tapes.
By the way, you DID try building a basic patch in the dead patch
locations..didknt you

On 5/30/09, JC < lawjcrg@... > wrote:
> most of my patches sound just fine.   The ones that I mentioned just don't
> produce any sound.   Does that help clarify the issue
>
> Also, do you (or anyone out there) have a good factory preset patch backup
> tape I could use   There's a digital form of one circulating on the internet
> but it's bad--doesn't load.
>
>
>
>
>
>
>
>
> Jonathan G. Chance, Esq.
> JC Law Offices
>
> 1840 Gateway Dr.
> Suite 200
> San Mateo, CA 94404
> 650-378-1383 (office)
> 650-921-4696 (cell)
> 650-429-2048 (fax)
> lawjcrg@...
> www.jchancelaw.com
>
> --- On Sat, 5/30/09, derrick simpson < atmospherics4@... > wrote:
>
>
> From: derrick simpson < atmospherics4@... >
> Subject: Re: [oberheim] obxa factory presets--do I have dead memory patches
> To: oberheim@yahoogroups.com
> Date: Saturday, May 30, 2009, 4:55 PM
>
>
>
>
>
>
>
>
> Did you check the audio out board....... .can you make a basic patch
> with osc,filter,vca
>
> If the machine sounds with a basic patch, the tape is bad or
> incomplete.. .you should be able to grab the vca knob and raise it to
> hear sound....... if you cannot hear the sound of the basic patch, your
> audio out board may not be seated or connected.
>
> I think some of those machines had an audio upgrade to stereo and this
> could be the culprit.
> Derrick
>
> On 5/30/09, lawjcrg <lawjcrg@yahoo. com> wrote:
>> Hello: at the cost of a small fortune, I've just successfully restored an
>> OBX-A that was left for scrap. My repair (surprisingly) had a backup tape
>> of the presets from another obxa that had come through his shop. Listening
>> to the presents that loaded in and comparing them to the preset chart in
>> the
>> owner's manual shows that most of these are the factory presets (there may
>> be a couple of the other owern's patches thrown in). Here's my issue. for
>> patch A3 and the last two groups (CD and ACD) if I push the patch
>> combinations, different lights light up, indicating to me that the patch
>> is
>> actually loaded and the synth has turned on the various parameters that
>> make
>> up that particular patch, e.g, saw versus other waves, unison or not, s/h
>> or
>> not, etc.--but NO SOUND comes out. What does this indicate There is
>> something wrong with the memory patch of the synth for those patches
>> Something else Thanks in advance for any suggestions.
>>
>>
>
>
>
>
>
>
>
>
>
>
>
>
>
>