See my comments below...

At 04:07 PM 3/31/2008 +0000, chthonic wrote:

thanks for the comments all around. there's not much to say about this synth...a friend
bought it non-working a few years back, intending to get it fixed...it's huge and taking up
space in our rehearsal room, we need money and are opting to sell rather than fix.

here's a general techie question, since people are asking about the voice cards... i can't get
the damn screws off of the cards to take them out and see which of them (if any) work or
don't work.

is there any good trick to loosen the screws without potentially damaging the voice cards

The screws normally had a blob of GPLT (deep red varnish) to secure them.  This should break free easily when you use the correct size Phillips screwdriver to remove the screws.  The screws should come out without any problem unless they are severely rusted.

-- Paul White
http://www.electrongate.com/dmxfiles/