Do we have a chart somewhere as to what NRPN parameters are controlled by particular messages (I'm only recently back here)
You can find a good discussion of how this works at the following link. I've built some RPN parameters to control pitch bend range, but I haven't dealt with NRPN stuff, though the sequencing of the messages should be similar.
http://www.2writers.com/eddie/TutNrpn.htm

> -----Original Message-----
> From: oberheim@yahoogroups.com [ mailto:oberheim@yahoogroups.com ]
> Sent: Tuesday, November 18, 2014 8:32 AM
> To: oberheim@yahoogroups.com
> Subject: Re: [oberheim] Re: Matrix-1000 Firmware 1.14
>
>
>
> I recently tested the V1.14 rev and was able to control the parameters
> using NRPN messages. I then put V1.13 back into my M-1000 and it
> ignored the messages. I haven't done a long term test or tested every
> value for every parameter but the fix works as advertised.
>
>
> It was quite a brain workout using Midi-Ox mapping with my Novation
> Remote LE. I'm still not sure exactly how to setup the MSB, LSB, and
> data CC's. It probably would have been easier to write a script. Does
> anyone have do this kind of real time editing all the time and could
> possibly offer some pointers or an online resource
>
>
> On Tuesday, November 18, 2014 9:08 AM, " sebo@...
> [oberheim]" < oberheim@yahoogroups.com > wrote:
>
>
>
>
>
> No, I just implemented the bugfixes, not the mods. For the mods
> you need the new CPU and clock.
>
>
>
>