test

The sysex numbers and the CC number are not the same and cannot be mixed.

The correct sysex to send to the K8P to change Matrix source 0 in hex is

$f0 - start sysex
$00 $21 $16 $60 - kiwitechnics ID
$04 - product ID of the K8P
$00 - Synth device ID - this has not been implemented and should be left as zero
$0e - command type - in this case you are wanting to send a parameter to the K8P
$01 - voice board select bit in the K8P - always $01 as the 8P only has the one voice
$00 $35 - parameter number (sent as two bytes) - this is the offset into the table and can be found on the $04 command type in the sysex tables
$xx $yy (data) - 0-32 decimal in this case - this is different for every parameter type and you should use the $04 sysex command table as a reference - this is sent as two bytes so for this parameter the first byte will be $00. The first byte is only used for 8bit & 12bit commands and shuld be zero for all others
$f7 - end of sysex

So to set the Matrix 0 Source to 1 the following should work
$f0 $00 $21 $16 $60 $04 $00 $0e $01 $00 $35 $00 $01 $f7

Clear as mud....

MH

On 23/12/2018 8:36 AM, pykup@... [kiwitechnics] wrote:

Hi,

can anyone send me an example of what should be the sysex i must write into a novation SL to control

matrix 1 source : (I hope with that example, i can do all the others)

here is the one I tried (not working)

f0 00 21 16 60 04 01 35 1 2 f7

I select ID 1 for the JX8P

I'm trying to implement sysex because CC commands are not active... I tried all reacting ones.

+ CC commands don't correspond to the ones indicated into the manual

ex: VCF1 resonance (42) reacts to CC 24

VCA DYN (52) reacts to CC 22

VCF cutoff hi (40) reacts to CC 23

etc.......

Hope you get what I mean

Cheers from France

previous	index	next
<<	topic list	>>

931 Re: [kiwitechnics] Sysex for KIWI JX8P