test

Hi Johan

The clocking system for the Arp & Seq have changed. There is now a master clock source which is set using Global 7 to internal/Ext or Midi and a separate seq & arp division factor. This is set using Global 8 for the Arp or the POLY button while in seq mode

These will be defaulting to the slowest speed as they have never been set yet. They are new parameters in the tone storage and if you haven't done a factory restore (don't as it will wipe everything) these parameters will have zero in them.

The set the Arp division go to global parameter edits and choose tone 8 (TAPE on : BANK D ; TONE 8) and set the division using the FX rate knob. The division factors are in the updated manual and include swing options. This is actually a Tone parameter and not a global one but there where no spare buttons to put it under. You will need to do this for each tone you want to use the Arp with.

The Seq division is set while in Seq mode (arp light flashing) by pressing the POLY button and adjusting the division with the FX knob. Again this is stored with the tone and you will need to set the division for each tone you want to use the seq with.

The Polysix internal clock runs quite slow as well which is fine if the clock is not divided but as this is done in hardware it would require soldering to change. You will find that a midi clock works more normally.

MH

On 12/11/2017 3:41 AM, johansahlberg@... [kiwitechnics] wrote:

I upgraded my Kiwisix to v 3 but I can't get the arpeggio to work, with or without the new sequencer mode. I've managed to record a sequence but when I try to play it it takes a long time, then it begins to play the seq at the sloooowest speed and turning the speed knob doesn't change anything, (but the LED flashes faster).

Dunno if it's just mine having this issue, but when I downgraded to v 2 the arpeggio worked again.

Software issue? Any ideas?

Best regards, Johan Sahlberg :)

previous	index	next
<<	topic list

856 Re: [kiwitechnics] Re: Kiwisix v3 has been released