Thank you, sounds great! But do you think that it might be possible that even if the light is all the way down to 1, that the sens is not actually all the way at the bottom of it's throw? Causing say the LFO mod to still be on slightly even if the light says otherwise? It is possible to have the LFO mod on the VCF to be zero right? That sounds like a stupid question I know but it really has me stumped, the sliders down, the light is at 1 (sometimes) but mod still present. I have a great tech around the corner that can take care of all this and even the install of the kiwi, I just want to be somewhat sure I'm not gonna get started on a kiwi CPU and it still has other major and more expensive problems. Thanks so much for your quick reply and your help thus far!
-AustinGreen

--- In kiwitechnics@yahoogroups.com , Kiwitechnics wrote:
>
> Almost certainly this is the Sense Slider. You can remove these,
> disassemble them and clean and regrease the inside in most cases. I will
> likely be full of stuff that has fallen into it. It would probably pay
> to get a tech to do this though as it is a little tricky.
>
> MH
>
>
> On 31/01/2013 3:26 p.m., billymccoy wrote:
> >
> > Hello All,
> > Thank you in advance for any help and advice! So I picked up a 3P in
> > hopes of making a kiwi upgraded machine but the eBay gods have screwed
> > me once again.
> > My problem (other than buying synths off evilbay,) is the sens knob
> > only goes down to light 2, not all the way down to 1. I've seen it
> > work correctly about 1/5 of the time but not sure the sound is
> > actually right because if I add some LFO mod to the VCF, I am unable
> > to bring the mod level down to 0. It seems even when the light goes
> > down to 1 there is still just the slightest bit of mod on the VCF,
> > also on the DCO (when LFO mod switched on but mod level is to zero,)
> > confirmed by the changing of the LFO wave or rate being still audible.
> > Anybody experience something like this? Does it sound like it might
> > just need a new sens slider? And if so, do y'all know a reliable place
> > I could find one?
> > Thanks again for any help!
> >
> >
>
> --
> Kind Regards
> Murray
> info@...
> www.kiwitechnics.com
>

-- Kind Regards Murray

info@...



www.kiwitechnics.com