Thanks Murray, that worked.

--- In kiwitechnics@yahoogroups.com , Kiwitechnics <yahoogroups@...> wrote:
>
> This is normally caused by the midi hardware not sending the full file.
> If you are using midiOX try reducing the buffer size so that is sends
> slower and your hardware can keep up. The PE can take midi at full speed
> but it is a large file and a lot of midi hardware has trouble. The
> bootloader file is small which is why it works.
>
> MH
>
> On 7/04/2012 5:50 p.m., rob_ocelot wrote:
> >
> > I seem to be running into a snag updating my PE to v4.8.
> >
> > My update hangs at B190 in the 'DO NOT Power off' screen. Cycling the
> > power brings up a v4.8 welcome message but it appears that only part
> > of v4.8 in actually in the PE. When I cycle through the synth
> > selection some of the screens are empty or are full of inverse letter
> > p's. Cycling the power again at one of these screens starts the PE for
> > the selected synth with the display restored. Display registers knob
> > and slider action but don't send anything to the synth.
> >
> > Bootloader is 2.9c, updated from 2.3d to 2.7c, then to 2.9c.
> >
> > Anyone else experiencing this type of problem? I'm thinking it's
> > something with my midi interface settings/timings. The bootloader
> > appears to be intact.
> >
> >
>