Hi Foraxx

Thanks for the feedback and I will be looking at the PG-200 issue shortly. The D8 parameter was changed to the settings you have found as it was more logical but while I changed the midi section I missed changing that section of the manual. This has been corrected and the manual is available for download.

The A10 is like that because the hardware in the 3P is all DCO1 when the value is maximum and all DCO 2 when the value is minimum. It was turned around for midi control to make it behave in a more logical manner. If it is too horrible to use I can look at making the sense slider reverse itself.

- MH

On 19/03/2012 5:56 p.m., foraxx wrote:

 

Hi,

I'm loving the new resonance level auto adjust feature. After updating to Version 2.30 I am noticing a few issues:

1) Connection of PG-200 programmer causes JX-3P to reboot, display version lights 2, 3, 8 and then freeze. Rolled back to Version 2.00 Build 8 and it works fine indicating PG-200 hardware is okay.

2) Parameter D8 (VCA Mode) does not select envelopes according to manual:

Sens 0 = light 1: (actual = Gate, expected = Env1)
Sens 5 = light 2: (actual = Env1, expected = Env2)
Sens 10 = light 3: (actual = Env2, expected = Gate)

3) Parameter A10 (DCO Mix) Sens slider edit is reversed. Increasing slider decreases value according to step key lights.