Assuming you are using v2, try turning off Global Parameters Group A:Bank B:8 & 9. This will switch off the passing of midi from the in to the out ports.
Midi Channels are also set in Group A:Bank B:1

Sorry the manual is hard to read. It's a little complicated. Print out a A3 colour copy of the Menu Map as that will help you to find your way around.

To edit the global parameters you press Shift (tape button), Group A: Bank B: then 1 to 16 depending on the parameter you wish to edit. There is a table of these in the menu map.

MH

On 6/11/2011 9:57 a.m., poiskaill wrote:

 

Hi,

Since I've installed the 3p ugrade, I don't recognize the use of my synth, and I feel really lost reading the 3p upgrade's manual.

The 3p has midi in & out connected (it's also my master keyboard).
I can get it work properly: there's a midi loop I can't get rid of (no loop before the upgrade).
Also, just with the midi in connected, a single note sent from Cubase and the 3p takes the notes and keep it alive, no way to stop it.

I have also the PE wich is working fine thru Cubase. No problem controlling the 3p on the same channel the notes were send.

How to go in 'global parameters' to set the midi channels 1 2

I think It should be a good start ;)