Hi

first of all: The 3P now sounds ground! Very good work.

But I have to admit I have troubles with saving tones and sequences.

If I try to save a sequence everything looks good, but if I change to
another sequencer, the store this sequence, and try to load the first
sequence, then the first sequence is empty.

The procedure is:
*Tape
*Seq write (enter sequence edit mode)
*Tone1 (select sequence No.1)
*enter notes
*Seq write (save the sequence to the selected place = No1)
*Tape
*Seq write (enter sequence edit mode)
*Tone2 (select sequence No.2)
*enter notes
*Seq write (save the sequence to the selected place = No2)
*Tape
*Tie (enter load sequence mode)
*Tone1 (to load sequence No.1)
*Start/Stop (should start this sequence playing) -> but nothing happens.

Am I doing something wrong?



If I try to save an edited tone, then the JX3P either does not store the
sound, and somethimes it jumps into some completely uncontrollable state
(some LEDs are lit or blink, no reaction on any button or key at all -
then only a hard power reset revives the synth).


Florian