> The odd thing is, it actually doesn't pick up the value that's in the patch, so it doesn't change anything at all :-)

It's a little confused with the detune amount I think. I will test this shortly.

> I also noticed by the way that the pitch change generated from the bender is not a perfect 2 semitones, 5th or octave, but something not very much in tune.

It's good on one of my 3P's and a little out on the other. I will check this shortly on the bad one but my guess is the max and min trim pots inside the 3P are not quite set right. VR6 is above the CN1 plug on the far left side of the front panel board next to the bender and adjusts the bender minimum and VR7 is next to VR6 and adjusts the bender maximum level. CN1 is the cable that goes from the front panel board to the bender unit.

I will take some pictures today when I adjust mine and add them to the manual. I will also add an adjustments section for tuning the bender and the DCOs. Both my 3Ps needed the DCOs done as they were a tiny amount out.

>
> Apart from that: the 3P now indeed has it's balls back, it sounds fantastic! I'm very happy with this new version!

Thanks for the feedback. I had a problem with the DCO waveform bias levels that slipped past early in the development and that had the effect of changing the waveform and making the triangle wave sound a bit thin and watery. It is now as it should be.

Regards
Murray