It is possible that the memory protect switch is on. That would stop the Factory Restore from working.

--- In kiwitechnics@yahoogroups.com , J <enjoyyoursoup@...> wrote:
>
> Hi Murray,
>
> This, I did.
> Is it possible to go back to 3pV1_5?
> I just had it working fine on this.
>
> Thanks,
>
> Jason.
>
> On Fri, Oct 7, 2011 at 10:13 AM, Kiwitechnics
> <yahoogroups@...>wrote:
>
> > **
> >
> >
> > Hi Jason
> >
> > It sounds like you have missed the last step (9 on the update notes), that
> > is doing a factory restore. You need to hold Edit Write & Seq Write buttons
> > while you power on the 3P.
> >
> > Regards
> > Murray
> >
> >
> >
> > On 7/10/2011 9:00 p.m., J wrote:
> >
> >
> >
> > Hi Murray,
> >
> > I have installed the update as instructed and now the JX3P does not make
> > any noise.
> > I must add that the update cycled as expected with it finishing on D on all
> > occasions.
> > All the buttons on the JX3P seem to be working and It is also responding to
> > Midi signals (flashing tape memory button)
> >
> >
> > Any suggestions?
> >
> > Thanks,
> >
> > Jason.
> >
> >
> > On Fri, Oct 7, 2011 at 3:09 AM, kiwitechnics <yahoogroups@...
> > > wrote:
> >
> >>
> >>
> >> I have checked all the older releases and the upgrade works on all of
> >> them.
> >>
> >> Regards
> >>
> >> Murray
> >>
> >> --- In kiwitechnics@yahoogroups.com , J <enjoyyoursoup@><enjoyyoursoup@>wrote:
> >> >
> >> > Hi Murray,
> >> >
> >> > I would like to upgrade to v2 though before I do so, I want to make sure
> >> I
> >> > do it right before it gets expensive for me.
> >> > I haven't updated the cpu since you re sent it to me, and therefore want
> >> to
> >> > know where I should begin from?
> >> > Is it ok to install the V4 bootloader straight away, or do I have to
> >> install
> >> > V3 to install V4?
> >> >
> >> > Thanks,
> >> >
> >> > Jason.
> >> >
> >> > On Thu, Oct 6, 2011 at 2:55 AM, kiwitechnics
> >> > <yahoogroups@> <yahoogroups@>wrote:
> >> >
> >> > > **
> >>
> >> > >
> >> > >
> >> > > Hi from Kiwitechnics
> >> > >
> >> > > I have just released a test version of v2. Anyone wishing to try this
> >> can
> >> > > download the files from the updates page. Keep in mind that this is a
> >> beta
> >> > > release and may still have problems. Please contact me with any bugs
> >> you
> >> > > find so they can be attended to.
> >> > >
> >> > > For those wishing to use the PE with this will also need the v4.1 PE
> >> > > firmware which has the new 3P v2 control codes.
> >> > >
> >> > > Regards
> >> > > Murray
> >> > >
> >> > >
> >> > >
> >> >
> >>
> >>
> >
> >
>