We have an internal technical document that describes how to modify an A-100
power supply (115 -> 230 and vice versa). Soldering experience and knowledge
of standard safety rules is required. The document is for experts only!
Definitely not recommended for laymen (danger to life in case of a mistake)!

Best wishes
Dieter Doepfer

> -----Ursprüngliche Nachricht-----
> Von: Doepfer_a100@yahoogroups.com
> [mailto: Doepfer_a100@yahoogroups.com ]Im Auftrag von nicholas_kent
> Gesendet: Donnerstag, 16. März 2006 04:10
> An: Doepfer_a100@yahoogroups.com
> Betreff: 1 A-100NT12 230v to 115v
>
>
> My appologies if this has been covered before (if so perhaps
> someone could just post a link).
>
> I have a case with a 230v A-100NT12 power supply. How simple (or
> complex) would it be to
> have it operate on 115v In other words is it a matter of
> jumpers (and of course proper
> electrical safety precautions) or a matter of the whole PSU
> needing to be swapped with a
> 115v one
>
> P.S. I already have a voltage converter but I'd rather not use it.
>
> thanks!
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>