apologies for the original double post.

Florian,

Thanks for the slap. I suppose I've seen this mentioned loads of times I
just never understood what the simple circuit was doing. Still not 100%
sure.......guessing that the gate "opens" the transistor, allowing the TIP
of the jack to connect to ground. Seems obvious now.

I will set to work on an interface right away, well...... Friday. I hope
anyone else with a Vortex will try something similar. I will soon have CV
control of one parameter at a time , syncable echoes, and triggered morph.
Now I want to make a module that will output only 2 triggers from the master
clock (or division thereof) at the push of a button for setting the TAP
TEMPO remotely.

Thanks again.

n keller

>From: Florian Anwander < Florian.Anwander@... >
>Reply-To: Doepfer_a100@yahoogroups.com
>To: Doepfer_a100@yahoogroups.com
>Subject: Re: 1 Interfacing VORTEX w/ A-100
>Date: Wed, 25 Jan 2006 09:51:20 +0100
>
>Hi
>
> > My question is how can I create a voltage-controlled, momentary
>"switch to
> > ground", so that I can activate a footswitch function with a GATE or
>TRIG
> > from A-100/MAQ16-3/MCV24
>Check http://www.doepfer.de/faq/gen_faq.htm#S-Trig
>
>I built such a adaptor to control the Arpeggio trigger of my Korg
>MonoPoly. Also my Moog Prodigy works fine with it.
>
>If you don't want to solder your self, then await the A-101-9. It should
> work also fine as Gate to S-Trigger converter
>
>Florian
>

_________________________________________________________________
Don�t just search. Find. Check out the new MSN Search!
http://search.msn.click-url.com/go/onm00200636ave/direct/01/