Hello,

this is a question I always wanted to ask about bus module functionality:
beside A-110, A-111, and A-140, are there any other modules that can use it
(get the signal from the bus)

Regards,

Zoran

>From: "selfoscillate" < synaptic_music@... >
>Reply-To: Doepfer_a100@yahoogroups.com
>To: Doepfer_a100@yahoogroups.com
>Subject: 1 Re: A-185
>Date: Tue, 27 Sep 2005 14:41:42 -0000
>
>
>hello bryan,
>
>from my experience you need the a185 only when sending a
>pitch cv to multiple origins, lets say you send a quantized
>voltage to three vco's and a filter. as long as you use a
>buffered multiple like the a185 you will be fine, but when
>using an unbuffered multiple like a180 the cv voltage will
>drop at a certain point and maybe your vco's will be out
>of tune then.
>the a185 feeds the system buss of the a100, so if you want
>to use the system buss, you need the a185.
>
>to shortly answer your question, you do not necessarily need
>an a185, but sometimes it makes life a lot easier
>if you have one.
>
>hope this helps
>
>best wishes
>
>ingo
>
>
>
>
>--- In Doepfer_a100@yahoogroups.com , "Bryan E Cornell" <bcor@l...>
>wrote:
> > I was looking around on the Doepfer site and I noticed the a185 Bus
>Access module. I'm not clear on what it does. If I send my Doepfer
>lfo to a bunch of different sources, will the signal somehow
>degrade I have a Doepfer suitcase system and I'm always sending the
>cv's to a multiple and then off to other places in the Doepfer system
>and to my other racks of Blacet/Wiard modules. I haven't noticed
>that this is a problem, but I'm not always very scientific about
>analyzing my patches.
> >
> > As my modular grows will I need the a185
> >
> > Thanks for any advice.
> >
> > Bryan
>
>