Hello Dieter,

The patches you describe here are both close to the unit I tried to decribe
(thanks for that!!).
However the lower voltage as an offset is a misunderstanding.
For as far as I remember it was so with the TMG at sonology that if you put
the lower and upper voltages
on the same level that it would only output that voltage. In both your
patches it also generates output below..
Maybe I'm wrong.. But I will defianately start investigating.
And also I would still be interested in a modulel ike this, saves a lot of
patchcords and modules I can use in the rest of the patch. ;-)
Anyway I will get back on this later this week after I have contacted my
sources at Sonology.

Friendly greetings,

Ernst

On 9/21/05, Dieter Doepfer < hardware@... > wrote:
>
> From my understanding this can realized with an A-149-1, VCA (e.g. A-132)
> and mixer (e.g. A-138a). The clock is the A-149-1 clock, lower CV goes to
> one A-138a input (kind of mixer offset), the A-149-1 output is processes
> by
> a VCA with VCA CV as upper CV, the VCA output goes to another mixer input.
> The mixer output is the Tendency mask generator output. The A-149-1 could
> also be replaced by an random module A-118 and a S&H A-148. In this case
> the
> clock goes to the A-148 clock input.
>
> I don't think that it justifies a new module even though it would be no
> problem for us.
>
> Best wishes
> Dieter Doepfer
>
>


[Non-text portions of this message have been removed]