I would like to add a send/return loop to the voltage rows of my A-155
so I can run the signals to A-156 Quantizer before routing them back
through the slew limiters inside A-155.

Any ideas Dieter

I know I could use the PRE-OUT as my send, so a single normalled
socket interrupting the signal going to the slew limiter would be all
I'd need to add...... but where exactly can I make this
interruption Shouldn't it be between the center pin of J2
(potentiometer board)....and where that trace branches off to C2 and
IC3,pin12

That seems correct to me, but all help is appreciated.

Thanks

n keller