Hey,

Thanks to Dieter for the suggestion. I have just installed this
mod/module. I now have the functional equivalent of the A-161 module, so to
speak, but connected to the A-155. My module is built on a blank 4HP
faceplate, same Doepfer style sockets, and includes LEDs just like A-161. I
made a simple circuit board to connect the sockets, leds, resistors, and
wires. Module disconnects from A-155 easily by 9 pin, male/female connector
(inside G6, behind modules). Total cost was about $22. Did anyone else try
this


nk

>From: "Dieter Doepfer" < hardware@... >
>Reply-To: Doepfer_a100@yahoogroups.com
>To: < Doepfer_a100@yahoogroups.com >
>Subject: AW: 1 Easy A-152 Question related to A-155 Sequencer
>Date: Wed, 3 Aug 2005 18:05:31 +0200
>
>The single triggers are available at the 8 center terminals of the
>trigger/gate switches (upper or lower row). You will simply have to add 8
>sockets that are connected to the center terminals e.g. of the upper
>trigger
>row (via 1k protection resistors to avoid problems with unintentional short
>circuits). One could e.g. use a multiple module A-180 and interrupt the
>connections between the sockets on the pcb and instead of this connect the
>8
>sockets to the switch terminals. Another solution would be to remove one
>row
>of switches and replace the switches by single trigger sockets. But from my
>point of view the trigger row witch switches is more flexible in most
>cases.
>
>It's only a mechanical "problem" (where to place the sockets) to add single
>trigger outputs, not an electronical one.
>
>Best wishes
>Dieter Doepfer
>
> > -----Urspr�ngliche Nachricht-----
> > Von: Doepfer_a100@yahoogroups.com
> > [mailto: Doepfer_a100@yahoogroups.com ]Im Auftrag von Zoran Bosnjak
> > Gesendet: Dienstag, 2. August 2005 18:34
> > An: Doepfer_a100@yahoogroups.com
> > Betreff: 1 Easy A-152 Question related to A-155 Sequencer
> >
> >
> > Hello,
> >
> > can somebody confirm if I am right on this: A-152 Voltage Addressed
> > Track&Hold / Switch can be used with A-155 to provide separate
> > trigger out
> > on every step (like Moog 960 sequencer, without trigger ins, of
> > course). Is
> > that correct Is there any other module that would do this (simple 8-way
> > switch) Regards,
> >
> > Zoran
> >
> >
> >
> >
> >
> >
> > Yahoo! Groups Links
> >
> >
> >
> >
> >
> >
>
>
>
>
>
>Yahoo! Groups Links
>
>
>
>
>
>

_________________________________________________________________
On the road to retirement Check out MSN Life Events for advice on how to
get there! http://lifeevents.msn.com/category.aspx cid=Retirement