Looks like it may be a single rail PSU as I can only see one large
smoothing cap so in that case it will only give +12V, however if it
is dual rail make sure you put a 1A fuse between each power rail and
your bussbars to limit current. Doepfer supply is 0.8 Amps, this is
a massive 3.4 amps - if you get a short anywhere there is sufficient
current here to burn the tracks off your bussbar and module PCB's

Other power supply to consider is the Condor (was PowerOne) HAA15-
08, it will give 1A per rail at 12 V (or 0.8A at 15V) and is used by
MOTM, has lower noise and better regulation than standard Doepfer
unit. Mouser part# 675-HAA15-0.8A, price $46.90

cheers,
Allan


--- In Doepfer_a100@yahoogroups.com , ben vehorn <mathlete23@c...>
wrote:

> Thanks to those who responded.
> I'm pretty sure the way they have it worded is confusing, but I

think

> that it's a 12V +/- supply at 3.4A (!).
> I went ahead and ordered one.... guess I'll find out. At that

price you

> can't go wrong! Looks like it has a fuse and switch already wired

up as

> well...
> I'll let the list know once it arrives.
> --Ben
>
> On May 13, 2005, at 1:42 PM, n keller wrote:
>
> >
> > Ben,
> >
> > I'm no expert, but unless that is a misprint in the description

it

> > will not
> > work. It is described as IN : +12-3.4A and OUT :

100/120/220/240 VAC

> > .
> > This is opposite of what you are looking for.
> >
> > Call me crazy, but I'm trusting D.Doepfer to provide the best

PSU for

> > his
> > products. Actually I just installed my second PSU2 into my

system

> > last
> > night, replacing one of the older PSU versions that always had a

loud

> > ambient hum. A PSU2 has more than enough power for a G6 frame,

so

> > I'll be
> > adding some bus-boards into another rack frame and "stealing"

some

> > power
> > from the G6 above.
> >
> > Good luck finding other solutions. Again I'm no expert.
> >
> > n keller
> >
> >
> >
> >
> >
> >
> >
> >> From: ben vehorn <mathlete23@c...>
> >> Reply-To: Doepfer_a100@yahoogroups.com
> >> To: Doepfer_a100@yahoogroups.com
> >> Subject: 1 Suitable PS for Doepfer
> >> Date: Fri, 13 May 2005 11:36:54 -0400
> >>
> >> Just wanted to confirm this...
> >> The following power supply should be suitable for a Doepfer

system,

> >> correct
> >>
> >> http://safe.spsp.net/cgi-bin/debco/OLS12C.html
> >>
> >> I'm building my own enclosure and will be using Doepfer bus

boards to

> >> distribute the power.
> >> Thanks.
> >> --Ben
> >>
> >
> > _________________________________________________________________
> > Don't just search. Find. Check out the new MSN Search!
> > http://search.msn.click-url.com/go/onm00200636ave/direct/01/
> >
> >
> >
> >
> >
> > Yahoo! Groups Links
> >
> >
> >
> >
> >
> >