hello anders,

if the other a190 also fails to work, it is
probably a problem with the cs15. afaik the
yamaha can be a pain if you want to use it with
midi-cv interfaces. i had bad experiences with
a cs20m years ago, i never got it in tune and
finally sold it, which was a pitty, because
i loved the smooth filter sound, especially
the highpass.

best wishes

ingo



--- In Doepfer_a100@yahoogroups.com , "Anders Eliasson" <anders@r...>
wrote:

> Good point!
>
> I've only tried one of them.
> I will try my other 190 before I do anything drastic! :-)
>
> Anders
>
>
>
>
>
>
>
> --- In Doepfer_a100@yahoogroups.com , "selfoscillate"
> <synaptic_music@y...> wrote:
> >
> > hello anders,
> >
> > does this problem occour with only one of your a190's
> > or on any of them
> >
> > best wishes
> >
> > ingo
> >
> >
> >
> > --- In Doepfer_a100@yahoogroups.com , "Anders Eliasson"
> <anders@r...>
> > wrote:
> > > Hello!
> > >
> > > I'm desperately trying to control my Yamaha CS15 with one of my
> > A190's. The
> > > gatepolarity is no problem and I've changed cv1 to Hz/v. But I
> > can't get the
> > > scale right! It starts out finer on 125mv but then it increases
> a
> > lot. The
> > > second octave should be 250mv but is 270mv. I've taken down the
> > scale to
> > > it's lowest point.
> > >
> > > What I have now is:
> > >
> > > 125mv should be:(125mv)
> > > 270mv (250mv)
> > > 560mv (500mv)
> > > 1,14v (1v)
> > > 2,3v (2v)
> > > 4,5mv (4v)
> > >
> > > Is it possible to trim I noticed there's one trimpot on the

pcb.

> > >
> > > Anyone that had a similar problem
> > >
> > > Anders E
> > >
> > > _______________________________________________________
> > > What's the difference between an extra-large pizza and a
> composer
> > > The extra-large pizza can feed a family of four.
> > > ______________________________________________
> > >
> > > Red River AB
> > > Skolvägen 18
> > > 730 91 Riddarhyttan
> > > www.redriver.se
> > > ___________________________________________________