hello coleman,
gate bus leds for midi the three leds of the bus
board are only for +12 -12 and +5 volts supply, not
for midi.
you mean the cv/gate leds of the a190 module that
doesn't proove that the cv/gate signal is transmitted
into the bus board, though.
are you sure that you haven't cut the two solder links
that connect the a190 cv/gate signals to the rack's
busboard also, are the two cv/gate singals jumpers
that connect the two halfs of the busboards in place
if you have the a190 in one side of the rack and the
vco's in the other and the jumpers are missing, then
you still do not get any cv/gate signals to these
vco's, as the bussboard is cut in two halfs(regarding
cv/gate distribution).
bakis.








--- H �ffffd8 R N < hornography@... > wrote:

>
>
> > What kind of device is fed by the CV-Out
> > Did you measure the note CV already with nothing
> connected to
> >
>
>
> It's connected to the bus, so I can see the gate bus
> LED's lit when
> there is midi data received, I have also tried
> patching it to any of my
> A110 VCO's, still no use. It's odd, i know that the
> IC is working,
> which would be the suspect thing if it were blown,
> as the gate outs are
> okay.. so any ideas
>
> Coleman
>
>
>
> __________________________________
> Do you Yahoo!
> Check out the new Yahoo! Front Page.
> www.yahoo.com
>
>
>

=====
Bakis Siros
Parallel Worlds / Polariton
Athens-Greece
1 group owner
http://www.shimarecords.co.uk
http://www.ward12.com



__________________________________
Do you Yahoo!
Check out the new Yahoo! Front Page.
www.yahoo.com