here are some a101/2 lowpass gate examples.
again and again and again the same drumloop,
i promise this was the last time ;-)
the signal coming from an a119 was fed
into the a101/2 audio input. the modulation
source in question was fed into the cv2 input.
no final vca, the a101/2 output was recorded
directly, of course the recording level had to
be re-adjusted on every take.
in the examples 1 to 5 an a147 lfo (sine) was
used to slowly sweep the lpg. the a147 was
reset on every loopstart.
examples 6 and 7 use the a119 envelope follower
output instead of the a147 for modulation.
these examples are nothing special,
compared to the a106 or a107 examples,
only simple sweeps and nothing fancy.
but the important thing about these examples
is that they show the general differences
of the modes and their changing character.
the real strength of the lpg is the
processing of oscillator waveforms.
i could have done that instead of using the
drumloop, but i had this idea a bit too late.
i can't post more examples for the next two
weeks. i'm quite busy with a couple of things
until friday and then i'll take some days off.
a full week without the internet. oh man,
this will be such a hard time ;-)