Hello,

I'm new to the list and Doepfer in general, so I apologize if my
follow questions are really obvious.

I've been piecing together a Doepfer setup over the last few months.
All the modules are going into an A-100G3 frame. A couple of days ago
I got a second VCO (a-110) and read that the A-100 bus can be set to
do Internal CV and Gate - to send both VCOs the same CV/Gate signals.
I do not have a full manual, but I downloaded the A100 "intro" pdf
from the Doepfer web page and it talks about "altering an internal
jumper" to set this up. I found the J1 and J2 jumpers between the 7th
and 8th bus board connectors. With the jumpers connected the internal
cv/gate did not seem to work. I pulled them out and still no internal
cv/gate. So my basic question is where do the jumpers get connected
to make internal cv/gate work Nothing on the bus board is
labeled "INT.CV" as it appears in the pdf. Also, do I need to do any
specific patching between VCO1 and 2 for this to work Finally, I'm
using a Kenton Prosolo to control the modular – should the Kenton
work ok for what I'm trying to do

Thanks so much