I'm not sure if your are talking about Analogue Systems or Analogue
Solutions modules. Your Subject says "ASystems" but your post
says "Analogue Solutions" first and later "A Systems RS"

I assume you are using a Doepfer bus board.

Analogue Solutions modules will plug directly into the Doepfer bus.
You just have to orient the red line on the cable correctly with the
Doepfer bus board, just as you would with a Doepfer module.

For Analogue Systems modules, the company makes a special cable.
Buying this cable from Analogue Systems seems a lot easier than
trying to rig one up yourself and it isn't all that expensive. You
need to make sure that the cable is plugged into the AS modules
circuit board correctly by looking at the markings on the board.
Then you need to orient the red line on the cable correctly with the
Doepfer bus board.



--- In Doepfer_a100@yahoogroups.com , "Antonio Grazioli"
<autodafe@t...> wrote:

> HI guys,
>
>
>
> I've home-built my Case for My Doepfer A100 modules. Now I want to
> integrate it with some Analogue Solution Modules.
>
>
>
> The cables are the same, but how are the power rails connected

Both use

> +12v/-12v and +5v.does anybody have schematics or can simply send

me a

> simple drawing of how the rails go in the A.Systems RS modules---
>
>
>
> Thx in advance.
>
> Antonio, Italy
>
>
>
>
>
> [Non-text portions of this message have been removed]