hi joost,
yes,the doepfer and a.sol. ribbon cables are the same,
AFAIK.the red stripe goes to the word"stripe" or to
-12volts.so,in most of the A.SOL. modules the ribbon
connector goes with the red stripe up.if you look at
the doepfer buss board and the SY02 pcb ,you will know
how to connect the ribbon cable.the ribbon cable goes
with the red stripe at the bottom in the doepfer
board!(stripe to -12volts.)
bakis.



--- levka0 < levka@... > wrote:

> Hi There
> I just got a used AS SY02 filter (could not wait for
> Doepfer's own MS-
> 20 reincarnation ;)), and I am wondering how to
> connect it.
> The AS site gives some advise; it appears that on
> the AS modules the
> -12 V pin is located at the top side of the
> connector (in contrast
> with doepfer's own modules); so it seems to me that
> AS should
> connect "upside-down" compared to Doepfer.
>
> Anybody here with a clue
>
> regards
> Joost
>
>

=====
Bakis Sirros
Parallel Worlds / Polariton
Athens-Greece
1 group owner
http://www.rubber.gr
http://www.ward12.com

__________________________________
Do you Yahoo!
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com