>i think this has been discussed before, but it's been a while.. what i
>di=
>d to eliminate hum on my a199 was use a much longer phono cable for
>connecting the reverb tank to the module and place the module as far away
>from any power supplies as possible. mine's about a meter away on a
>shelf.=
>you'll need to drill a hole in the bottom of the case in order to pass the
>=
>cable through (and if you pass the cable through BEFORE solderig the phono
>plug
>onto the end you can use a much smaller hole). got rid of all hum for
>me..=

I did the same except I just removed the back panel, ran the cable out and
refitted the panel. No holes. No fuss. I found that I didn't even need to
extend the cable, I just experimented with orientation of the spring unit
until the hum disappeared.

Pierre

_________________________________________________________________
Unsatisfied with being single Try MSN Personals
http://www.msn.co.za/personals/