From: Bakis Sirros <synth_freak_2000@y...>
Date: Mon Jun 2, 2003 9:03 pm
Subject: Re: 1 Re: Blown fuse again!

Hi Bakis,

I hope that the cause. I noticed that on one of
the connector's, the highest pins, where bent a
little to the outside. I remember having trouble
getting it connected! Now, this evening when I
checked I saw that this connection was indeed
not right and could explain the blown fuses.
Alas, the suggestions of Dieter you uploaded
I can't use this evening anymore, cause I have
no right fuses left. So tomorrow evening I will
try it.
No, the volts have been and are the right ones,
no doubt about that.

Roel

Bakis wrote:

>hi roel,
>so,it seems that the problem is in the case's bus
>board!as all the new modules have worked in your
>other(older) doepfer case,they seem to be ok!
>as far as i know from dieter,yes, a wrong connection
>to the bus board can lead to a blown fuse!
>but,also, check that your new "defective" doepfer case
>is set for 230 volts(europe)operation and NOT for 115
>volts!

bakis.