Hi se

> same with me, but a single meter would be enough for me.
> if there is a need for two meters, we can buy two
> modules. this would save space and money, if only
> one meter is needed.

Agree, but it might be possible to get two meters into an 8HP module
at low cost. If so it would be fine that way, no

> buffered outputs would be nice too (2 normal outs and one
> inverted out).

Definitely mini-multiple jacks like the voltage invertor at a minimum,
but buffered would be much nicer.

>
> the moving coil meter is accurate enough i think.

Hate to admit to this, but I think it would also look cooler :-)

> the dc/ac switch is a must. i would mainly use it dc-coupled
> with -/+ scale, but ac-coupling is important too.

Absolutely agree

> the combination of attenuator and vu-meter is not a bad thing,
> but i would prefer two separate modules for these tasks.

Agree again. You can always patch an attenuator to the meter, but you
can't "un-patch" a combination module if you need the two functions to
operate independently of each other.

Regards,

Joe