hi neil,
i don't know about all these connections in the a110
pcb's ,but in anyway if you have bought the minisystem
new from doepfer the a190 should send gate to the
a140's(the a140 jumpers should be in place...)and also
the a110 should receive the cv signals.
so,if you have any doubts,contact dieter doepfer
direct!
bakis.



--- "neilwight < neilwight@... >"
< neilwight@... > wrote:

> tim,
>
>
> thanks a million for your reply.
> i went back inside the A100 armed with your info and
> some ideas it
> had created.
> i had previously checked the links on the A190 also
> before posting.
> the jumper however on the ADSR unit was indeed
> missing as you had
> suggsted so i put one on and problem solved. doh
> !!!!
> with regards to the a110 VCOs,
> i had a close inspection of the units and the PCBs,
> after about 15
> minutes of scrutinising i noticed two boxes printed
> and labelled int
> cv. one at the bottom right handside, near to the
> blue adjustment VR
> and the other at the top left near to where the mini
> jack for cv
> comes in.
> these were both unconnected to anything and had
> clearly never been
> (holes were perfectly clean, no old solder traces
> etc) and it was
> the same on all three VCOs.
> as an experiment i wired them together on one of the
> units and hey
> presto, full cv response.
> can anyone confirm that these points should in
> actual fact have a
> wire conencting them together before i go ahead and
> connect and
> solder them properly.
> i suspect so but just would like to check.
>
> cheers,
> neil
>
>
>

=====
synthfreak(parallel worlds)
athens-greece
1 group owner-moderator

__________________________________________________
Do you Yahoo!
Yahoo! Tax Center - forms, calculators, tips, more
http://taxes.yahoo.com/