Florian,

Terrific idea, it would save cost by not having to duplicate electronics
in every module and would provide a level of flexibility which is what
modular systems are all about.

Regards



David Salter
Reuters Consulting
Tel: +44 20 7542 2402
Mob: +44 7990562402
Fax: +44 20 7542 2699

-----Original Message-----
From: Florian Anwander [mailto: Florian.Anwander@... ]
Sent: 04 February 2003 08:19
To: Doepfer_a100@yahoogroups.com
Subject: Re: 1 digital bus, was: NEW INFO


Hi Bakis

> doepfer should manufacture the touch
> sensor keyboard with all the a154 features included
> AND the a154 module to enable all the a155 users out
> there to greatly enhance their a155 features!!!

I think, the solution might be a standardized digital bus for
sequencer
orientated modules. Accessible from the front side of the
modules. 10 pins
should be enough for a 5Bit-addressing (=32 Steps), clock,
start/stop,
reset and ground and +5V. Doepfer could use the same ribbon
cable that is
used for the supply voltages.

If such a bus exists, modules and keyboards simply could be
combined.

Florian

To unsubscribe from this group, send an email to:
doepfer_a100-unsubscribe@yahoogroups.com



Your use of Yahoo! Groups is subject to the Yahoo! Terms of
Service < http://docs.yahoo.com/info/terms/ > .




-------------------------------------------------------------- --
Visit our Internet site at http://www.reuters.com

Get closer to the financial markets with Reuters Messaging - for more
information and to register, visit http://www.reuters.com/messaging

Any views expressed in this message are those of the individual
sender, except where the sender specifically states them to be
the views of Reuters Ltd.



[Non-text portions of this message have been removed]