Hello Dieter,
Many thanks for that suggestion. I'll check it out.
Regards,
Michael.

Sent from my iPad

> On 8 Jan 2018, at 08:38, yahoo@... 1 < Doepfer_a100@yahoogroups.com > wrote:
>
> Hello Michael,
>
> I'm sorry about the problems with the module.
>
> Please check if the jumper that connects the CV out to the bus is removed
> (to eliminate a problem caused by another CV transmitter on the same bus
> board).
> If that's fine I assume that the fault is caused by be a broken glide
> potentiometer (or broken wire) and I ask you to return the module to Thomann
> for repair.
>
> Best wishes
> Dieter Doepfer
>
>> -----Ursprüngliche Nachricht-----
>> Von: Doepfer_a100@yahoogroups.com [mailto: Doepfer_a100@yahoogroups.com ]
>> Gesendet: Sonntag, 7. Januar 2018 16:20
>> An: Doepfer_a100@yahoogroups.com
>> Betreff: 1 A-190-3 apparent failure
>>
>>
>> Hi,
>> My A-190-3 MIDI module has apparently failed on the CV output. On
>> my 'scope it shows -5v constant and there is no variation in the
>> note pitch when connected to V/octave socket on any of my
>> oscillators. I drive it from my MAQ 16/3 and I've checked the
>> MIDI out on that with a Kenton Control Freak SE in its MIDI
>> analyser mode and that is perfect.
>> The gate output of the A-190-3 is operating perfectly.
>> My question is, is there anything I can check before sending it
>> back to Thomann as it is still under warranty
>>
>>
>> Regards,
>> Michael.
>
>
>
> ------------------------------------
>
> ------------------------------------
>
>
> ------------------------------------
>
> Yahoo Groups Links
>
>
>