Then it should be no problem. Simply mount the R2M manual to a 1U blind
panel by means of the four M3 threads at the bottom of the R2M manual
housing. The lenght of the R2M manual is ~ 600 mm (plus the USB connector).
If the width of the case is more it should work. I'd recommend to keep the
housing as it guarantees the mechanical stability required for the pressure
and position sensors.

Best wishes
Dieter Doepfer

> -----Ursprüngliche Nachricht-----
> Von: Doepfer_a100@yahoogroups.com [mailto: Doepfer_a100@yahoogroups.com ]
> Gesendet: Montag, 14. November 2016 10:58
> An: Doepfer_a100@yahoogroups.com
> Betreff: Re: 1 R2M Manual Ribbon controller - 1U row
> installation
>
>
>
>
> Thanks, though I imagined a row longer than 84hp, there's some on
> sale of 90HP, 104HP, 1 row @ 3U + 1 row @ 1U. I do believe that
> Intellijel makes it. Of course, then it would require some work
> to manufacture a panel to host the Manual.
>
>
> Best regards, Diego
>
>
>
> Il giorno 14/nov/2016, alle ore 10:45, yahoo@...
> 1 < Doepfer_a100@yahoogroups.com > ha scritto:
>
>
>
> I'm sorry, this will not work because the position sensor is longer than
> 19". The active area of the position sensor is 500 mm plus the
> area required
> for the connector (~ 70mm). That's more than 19" which is about
> 483 mm. It's
> not possible to shorten the positions sensor without damaging the
> sensor (in
> contrast to the pressure sensor which can be easily shortened).
>
> Best wishes
> Dieter Doepfer
>
> > Hello,
> >
> > is there anybody who tried to ease installation of the manual
> > onto a 1U eurorack row
> >
> > Thanks
>
>
>
>
>
>
>
>