test

You could even use a scanner, rescale the image so the dimensions of the panel are consistent with real life (if not already to scale), then trace on a different layer and eventually remove the original image leaving just the trace. Print and compare to real life. I've done this when I've had an old pcb flex and crack and the manufacturer has not existed for decades and it was surprisingly easy.

On 4 Apr 2016, at 16:56, achtung_999 heinrich.himmelwasser@... 1 < Doepfer_a100@yahoogroups.com > wrote:

ehmmm maybe a stupid remark, but since you have the module yourself: measure maybe

On Mon, Apr 4, 2016 at 1:33 PM, thomas_escure@... 1 < Doepfer_a100@yahoogroups.com > wrote:

Thank you Stuart for your reply.

I've used Schaeffer services several times too, but what I need is an exact info for the placement of jacks and pots holes. I would not like to make something approximate, as I don't want to stress the solder joints while screwing the electromechanical components to the panel...

Regards,

Thomas

previous	index	next
<<	topic list	>>

26940 Re: 1 Template for A-176 faceplate