Yes, this circuit should work. But I'd reduce the value of the potentiometers a bit (e.g. 10k) to obtain a more linear control
behaviour. A 100k potentiometer with a 100k load (typical load value) has a very non-linear control scale. With a 10k pot that's
much better. Of course the best solution would be a buffer for each potentiometer output but that's probably a bit over the top.

Best wishes
Dieter Doepfer

> -----Ursprüngliche Nachricht-----
> Von: Doepfer_a100@yahoogroups.com [mailto: Doepfer_a100@yahoogroups.com ]
> Gesendet: Montag, 14. März 2016 21:33
> An: Doepfer_a100@yahoogroups.com
> Betreff: Re: AW: 1 DIY cv out module to accompany A152
> question
>
>
>
>
> Dear Dieter (and all),
>
>
> Many thanks for taking the time to reply to me!
>
>
> Further to your advice could you (or anyone else) tell me if this circuit I have drawn will work using an LM7808 8v
> voltage limiter
>
>
> https://dl.dropboxusercontent.com/u/536105/8x8v%20CV.jpg
>
>
> (I have only drawn 4x CV outs on it)
>
>
> Best wishes,
>
>
> Neal
>
>
> PS Dieter I cannot thank you enough for your A100 Eurorack system– it has always been my dream to own my own modular
> synthesiser– and because of your designs, I can...! :)
>
>
>
>