This is very difficult to answer IMO as only you know what you all cabled.
I have bought this: http://www.schneidersladen.de/en/xaoc-devices-karl-marx-stadt.html and the module works perfect.

Have fun,

------------------------------------------------------
Danny Budts
info@...
www.syndromeda.be
https://www.facebook.com/Syndromeda
https://syndromeda.bandcamp.com/
https://www.facebook.com/pages/Syndromeda/189901007722025 ref=hl


----- Oorspronkelijk bericht -----
Van: funster21wi@... 1 < Doepfer_a100@yahoogroups.com >
Aan: Doepfer a100 < Doepfer_a100@yahoogroups.com >
Verzonden: Wed, 27 Jan 2016 06:02:59 +0100 (CET)
Onderwerp: 1 Doepfer DIY questions

Hey guys,


So I've been putting together one of these Doepfer DIY kits, and have finally gotten to the point where I can test it. I basically followed the example drawing in the back of the manual. I have a couple of questions, if anyone can offer any help I'd greatly appreciate it!


1. When I first hooked up the audio out I got a lot of really horrible buzz, after poking around for quite a while I noticed that if I shorted the other side of the stereo 7mm jack to ground it seemed to get rid of the noise, but I had to turn my amp way up in order to hear it! Is this how I should have done this, or am I missing something altogether


2. In general, how, if at all, should the metal face plate I'm using be grounded At the moment it is not, I don't seem to be getting any additional buzz from touching the case.


3. When should the ADSR LED light up For the longest time I hadn't seen it light up at all, but after some prolonged screwing around it would start to pulse, but I wasn't really sure what had happened to make that start working.




Again, any info at all would be appreciated,


Thanks!