Hi Eric

> in one of my earlier postings I asked for the step skipping (on/off)
> feature, I still think it
> is one of the most important extra features (well in my case it is...)

What do you mean with step skipping exactly:

1.) The address counter should skip one step, reducing the lenght of the
sequence like: 1 2 3 5 6 7 8 = 7 steps
or

2.) The address counter should give all steps, but on certain steps there
is no gate signal, like:
CV : 1 2 3 4 5 6 7 8
Gate: x x x . x x . x


To my opinion the latter makes sense, but the first proposal is quite
sensless. Instead of you could use a reset function.

For the second proposal I would prefer a additional gate sequencer with
three position switches:
up=bound (the gateout is logical YES for the whole step length)
middle=normal (Gate pulse).
down=no gate for this step


Florian
--
Florian Anwander |ConSol* HP-Support
Tel. +49.89.45841-133 |Consulting&Solutions Software GmbH
Fax +49.89.45841-139 |Franziskanerstr. 38, D-81669 München
email: florian.anwander@... | http://www.consol.de