Alas, Christian says that it is currently an unsolved problem. Hmm… It’s early for me still, I haven’t had enough coffee and I am not near the unit. So an external clock will solve the problem and a A-160-5 will want the external clock anyway, correct Do I run into any problem if I still have the A-154 connected to the A-155 but am clocking it with an external clock (4MS QCD for example) parsed through a A-160-5

I do very much appreciate the system you built, Dieter, and the fact that we can reach you through this group.

Best,

Kazys

> On Jun 8, 2015, at 5:37 AM, yahoo@... 1 < Doepfer_a100@yahoogroups.com > wrote:
>
>> Same here, I’ve got used to it but is annoying!!!
>>
>>
>> Neil
>>
>>
>> On 7 Jun 2015, at 17:46, Kazys Varnelis kvarnelis@... 1 < Doepfer_a100@yahoogroups.com > wrote:
>>
>>
>> I have the A-154/A-155 sequencer and controller. It seems to me that something is off in the clock knob. Perhaps its just
>> a logarithmic or exponential slope but until around 2pm on the knob, the increment to the clock proceeds very slowly. At
>> that point, there is a huge jump and afterwards it moves very fast. This makes the combo very difficult for me to use as
>> is. Any thoughts
>
> Please contact Christian Assall ( software@... ). He programmed the A-154 firmware. I'm sure there is a solution for this
> problem.
>
> Best wishes
> Dieter Doepfer
>
>
>
> ------------------------------------
>
> ------------------------------------
>
>
> ------------------------------------
>
> Yahoo Groups Links
>
>
>