Hello,

I don't have access to the schematics of the DE's, but it should be
possible basically.

You have to pick the voltage from the slider contact of the tuning
potentiometer of DE1 and feed it to an additional socket on the DE1

In the DE2 you have to add a socket and a resistor. The resistor is a
duplicate of the existing resistor that is connected already to the
existing tune potentiometer (there is a tune range Jumper too, which may
hav to be obeyed). The socket feeds this additional resistor.

Now you have to connect the two sockets with an patch cable. DE1 will be
the master tune. On DE2 you still can adjust the offset tuning.


To get an idea of it, have a look at the schematic of the A-110
http://www.doepfer.de/a110_s.gif
On the left you find the existing tune-potentiometer (P1). R5 (right to
it) is the existing resistor.
The additional socket and resistor will look like BU2 and R6 (don't obey
the given values and the connection to "int.cv" !).


For the exact values of the resistors and for the places on the pcb
access to the schematics would be required. (Dieter )


Regards
Florian


Am 05.01.2015 um 10:22 schrieb racc00nb0y@... [Doepfer_a100]:

>
>
> Thought so.
>
> I wonder if there is any way to modify this. I guess it's not that
> much effort to just tune them :D
>
>